retgiga.blogg.se

1. #Configure symantec backup exec 2014 with nas install#
2. #Configure symantec backup exec 2014 with nas download#

Ndmpd kill Terminates the specified session when used as "ndmpd kill XX".ĩ) The only debugging options are turning on Backup Exec live debugger SGMon's Device and Media option with Verbose Logging and debugging NetApp ndmpd. Ndmpd status Displays the current state of each NDMP session. Using the probe option without specifying a session parameter displays NDMP information for all active sessions. Ndmpd probe Displays detailed information about a specific NDMP session when used as "ndmpd probe XX". Sysconfig -m Displays tape library information. Sysconfig -t Display device and configuration information for each tape drive Display detailed information about each I/O device. Sysconfig -v Display NetApp filers configuration. Storage show mc Information about all media changer devices is shown. Storage show tape Information about all tape devices are shown.

#Configure symantec backup exec 2014 with nas download#

If the tape drive is not listed download the latest tape configuration file (.tcf) from NetApp or contact NetApp technical support. Storage show tape supported - Displays a list of tape drives supported by the NetApp Filer. The following commands can be used for diagnostic troubleshooting: To set the NDMP level to "4" type the following command on the Filer:Ħ) The NDMP device must be configured to use the challenge (MD5) method for authentication by using the following command:Ĩ) If the tape device is not detected by Backup Exec confirm the tape drive and library are detected properly on the NetApp filer. To check the NDMP Version, type following command on the Filer : If the level is below "4" then backup is not possible. Note: Make sure NDMP Version on the Remote Filer is set to "Level -4". The NDMP Service can be started by entering the following command on the NDMP device The OnTap Version can be checked by entering the following command (accessed using telnet or the web interface or local login):ĥ) In order for Backup Exec to back up NDMP resources, the NDMP service must be running on the NDMP device.

#Configure symantec backup exec 2014 with nas install#

3) Install NDMP Option license on the Backup Exec for Windows Media ServerĤ) NetApp Filer should be running OnTap 7.0.3 or greater.